Adjusting Head Rest Components; Figure 3-6: Fiber Optic Camera In The Tower Mount - SR Research EyeLink 1000 Installation Manual

3.3

Adjusting Head Rest Components

The height of the forehead and chinrest can be adjusted by loosening the knobs on both sides
of the Tower. After sliding the chinrest to the desired position, re-tighten the knobs.
Set up the monitor and chinrest so that the chinrest is centered on the monitor and the
monitor is horizontally aligned with the chinrest (HINT: measure from the left and right
knobs on the chinrest to the left and right sides of the top of the display area of the
monitor, these should be equal).
Adjust the tilt of the monitor and height of the forehead rest. Ideally these should be set so
that the top of the display is at about the same height as the forehead rest, and the display
is tilted up slightly. The tilt can be changed if there are any reflection issues. Please follow
"Section 8.4 Customizing Your PHYSICAL.INI Settings" to modify the PHYSICAL.INI file
settings.
Continue to Chapter 8 "Testing the Host PC Installation"
20 Tower Mount Installation
2005-2010 SR Research Ltd.

Figure 3-6: Fiber Optic Camera in the Tower Mount