Analog Card Installation - SR Research EyeLink 1000 Installation Manual

back of the Host PC as indicated by the label "EyeLink Button Box". Use an optional USB
extender cable if the game pad needs to have a cord longer than one meter.
NOTE: If you have a USB Button Box, it must be directly connected to a
USB port on the Host PC and cannot be connected through a USB hub.
Use of an Optional Parallel Port Expansion Card. The EyeLink Host PC can be used with
an optional Parallel Port Expansion Card from SR Research. While the default configuration
expects the VPixx Button Box or Modified gravis Destroyer Gamepad to be plugged into the
motherboard's parallel port, it is possible to use these with the expansion card by copying and
renaming the {EYELINK Drive}:\ELCL\EXE\BUTTONS.EXP file as {EYELINK
Drive}:\ELCL\EXE\BUTTONS.INI – which configures the expansion port as the default.
BNC Connector Label
0
1
2
3
4
5
STST
Table 1: Analog Card BNC Connector Information

2.4.5 Analog Card Installation

If an optional Data Translation analog card was purchased with your system it will require
additional cabling steps.
Analog Card Pre-installation Checklist
2.4.5.1
If an analog card option was purchased, you should also have:
1. Full length PCI Analog card (already seated in the Host PC if your system comes
preconfigured).
2. Analog breakout board with BNC connectors.
14 Installation and System Cabling
2005-2010 SR Research Ltd.
Eye Data
Monocular: X
Binocular: Left X
Monocular: Y
Binocular: Left Y
Monocular: Pupil Size
Binocular: Left Pupil Size
Monocular: -
Binocular: Right X
Monocular: -
Binocular: Right Y
Monocular: -
Binocular: Right Pupil Size
Strobe Line
Line
DAC0
DAC1
DAC2
DAC3
DAC4
DAC5
STST