Figure 5-5: Cables Emerging From The Bottom Of The Lcd Arm - SR Research EyeLink 1000 Installation Manual

2. The remaining cables emerging from the LCD Arm connect to the LCD monitor as
follows (Figure 5-4 bottom):
Insert the phono plug connector into the audio input jack on the bottom centre
of the LCD monitor of the Camera and LCD Assembly.
Connect the SVGA cable to the SVGA input on the right of the LCD monitor.
Tighten the screws by thumb or use a slotted screwdriver.
Connect the three-prong power cable into the LCD monitor power input on the
left side of the monitor.

Figure 5-5: Cables Emerging from the Bottom of the LCD Arm

3. The following cables coming out of the bottom of the LCD Arm (shown left-to-right in
Figure 5-5) are to be connected as described below. Extension cables are supplied as
indicated in the text above. The first cable is the camera high-speed data cable and goes
to the Host PC, the next two cables go to outputs on the Display PC, and the final two
go to a power source.
Connect the thick CameraLink cable emerging from the bottom of the LCD Arm
to the EyeLink card on the Host PC. Be sure to tighten the thumbscrew
connectors or use a slotted screwdriver to make a tight connection.
Connect the supplied SVGA extension cable to the SVGA cable coming out of the
bottom of the LCD Arm Mount. The female end of the cable coming from the
LCD Arm attaches to a male connector on the extension. The extension's female
end attaches to the Display PC video card output port.
Connect the supplied audio cable extension (female end) to the 3.5 mm (1/8")
mini-plug on the audio cable emerging from the bottom of the LCD Arm. Insert
the male end into the audio output jack on the Display PC.
Connect the supplied three-prong power cable (female end) to the camera power
supply (male end) that is attached to a cable coming from the bottom of the LCD
Arm. The male end plugs into a power source.
Connect the supplied three-prong power extension cable to the LCD monitor's
power input and plug the male end into a power source. The power supply in the
32 LCD Arm Mount Installation
2005-2010 SR Research Ltd.