Option 1: Remove Lcd Arm And Camera Assembly As A Unit; Option 2: Remove Camera Assembly Then Remove The Lcd Arm - SR Research EyeLink 1000 Installation Manual

the table. Be careful when handling the shim, as it may have sharp edges created around the
center hole from the pressure applied to it.

5.8.1 Option 1: Remove LCD Arm and Camera Assembly as a Unit

First fold the LCD Arm as pictured in Figure 5-6. The Camera and LCD Assembly can be
lowered so that the camera bracket is beneath the bottom limb of the LCD Arm. Raising it
slightly can put pressure on the cable cover which may mark the cover, so some packing
material may be inserted between these to prevent marking if desired.
Wrap Velcro (soft side against the LCD Arm is recommended) around the LCD Arm so that it
will not extend when lifted (see Figure 5-6). Although full LCD Arm extension is prevented by
the camera bracket pressing against the cable cover, the possibility exists for body parts to
become pinched.
The entire LCD Arm, with intact Monitor Assembly, can now be lifted from the Arm Base. One
person may need to apply downward pressure to the table while the other does the lifting, so
that the table is not merely lifted off the floor. Some wiggling of the LCD Arm and its shaft may
be required to make it come free from the Arm Base's holder cup. Once free the unit may feel
top heavy, so be sure to have a strong grip. Gently lower the unit onto an awaiting soft foam
surface, such as the inside of a hard shell case molded for transport and storage of the LCD
Arm Mount.

5.8.2 Option 2: Remove Camera Assembly then Remove the LCD Arm

Fully extend the LCD Arm and ensure there is nothing preventing the upwards lifting of the
Camera and LCD Assembly. One person will have to steady the LCD Arm and put downwards
pressure on the top of the LCD Arm while the other person grabs onto the monitor handles and
lifts upwards. Some rocking of the Monitor Assembly back and forth to dislodge it may be
necessary.
Once free of the cup holder, the Camera and LCD Assembly can be placed on a hard surface
with the bracket making contact with the table. At this point the LCD Arm can be removed
from the Arm Base with one person applying downward pressure on the table while the other
person lifts up on and wiggles the LCD Arm free of the Arm Base.
Continue to Chapter 8 "Testing the Host PC Installation"
LCD Arm Mount Installation 35
2005-2010 SR Research Ltd.