Introduction; Tac Xenta Op; This Manual - t.a.c. Xenta OP Handbook

TAC Xenta OP Handbook
1

Introduction

1.1 TAC Xenta OP

1.2 This manual

TAC AB, 2001-08-08
TAC Xenta OP is a small operator panel designed to be used together
with TAC Xenta 100, 300, 401 and 901 units.
The operator panel gives the user access to parameters and alarms
without communicating with a central system. Additionally, it is used
to monitor status, adjust setpoints and time channels. All values are
displayed with an explanatory text in the alphanumeric display win-
dow.
Please note!
The TAC Xenta OP and the other products of the Xenta family must
not be used for any other purpose than that for which it was designed.
Installation and repair may only be performed by authorized person-
nel.
This handbook has the following contents:
Chapter 2
In this chapter the connection of the operator panel, TAC Xenta OP,
to the TAC Xenta 100 and TAC Xenta 300/401 controllers is shown.
Chapter 3
The use of the OP together with TAC Xenta 100 and the principles for
handling display of Network Variables are explained in this chapter.
Chapter 4
The use of the OP together with TAC Xenta 300/401 controllers and
the most common menus are discussed here
1 Introduction
0-004-7506-4 (EN), 7 (36)