Selecting The Op Communication Mode - t.a.c. Xenta OP Handbook

TAC Xenta OP Handbook

2.6 Selecting the OP communication mode

Xenta 100: ON/OFF
Connecting to
Xenta Base unit
OP Service menu
1. Exit service mode
2. Keyboard test
3. Display test
.
10 OP mode
Change OP mode
Xenta 100 : ON
Bindable : TAC
Press enter to
access Xenta 100
Connecting to
Xenta 100 ...
TAC AB, 2001-08-08
When delivered, the OP is set for Base unit (TAC Xenta 300, 400)
communication. To change the communication mode, you have to call
up the OP Service menu and go to the 10.OP mode menu, where the
TAC Xenta 100 mode can be turned on/off.
Change OP mode
Xenta 100 : OFF
Bindable : TAC
Use + or – to change the Xenta 100 mode and press
When the OP is set to allow the Xenta 100 mode, the operator is given
a choice to access TAC Xenta 100 (in stead of TAC Xenta 300/400)
by pressing "Enter", each time an OP is connected.
The OP Service menu cannot be reached when the OP is in the Xenta
100 mode.
If you want to turn OFF the Xenta 100 mode, once you are in this
mode, you must temporarily disconnect the OP and let the OP revert to
the Base unit communication mode in order to be able to reach the
Service menu and from there select the 10. Change OP mode
menu.
The TAC Xenta 100 OP communication is described in the next chapter.
"Bindable" is explained after the Summary below.
Summary
To turn ON the Xenta 100 mode
1 Connect the OP and wait for message on display.
2 Press both keys
simultaneously.
3 Select 10.OP mode menu.
+
–
4 Press or
.
5 Temporarily disconnect the OP and wait for message on display.
6 Press to access Xenta 100.
7 Wait for message on display.
2 Connection and Basic Functions
. and for about three seconds
to set the Xenta 100 mode ON and press
0-004-7506-4 (EN), 15 (36)
.