Connecting To Tac Xenta 300/401 - t.a.c. Xenta OP Handbook

TAC Xenta OP Handbook

2.3 Connecting to TAC Xenta 300/401

TAC Xenta 300/401
controller
Socket and screw terminals for
the TAC Xenta controller
connection
1
C1 C2 G G0
TAC Xenta OP connectors and contrast potentiometer
TAC AB, 2001-08-08
Cable between controller and Operator panel...................... max. 10 m
When connecting the operator panel there are two alternatives (please
refer to the adjacent figures):
• Use the modular socket on the front of the TAC Xenta 300 or 401
controller and the corresponding socket on the back of the operator
panel. This requires a special cable.
• Use the screw terminals on the back of the operator panel, la-
belled 1–4. Terminals 1 and 2 are used for communication and
terminals 3 and 4 for 24 V AC (or DC).
At the controller you use the terminals C1, C2 and G, G0.
Socket for
connection to the
operator panel
2 3 4
The contrast of the display can be adjusted with the potentiometer on
the rear of the operator panel.
(The Service pin is available from the rear if, in special cases, the
network configuration procedure requires this. When the pin is
pressed, a unique hardware identity code is sent on the network.)
2 Connection and Basic Functions
Service pin
Modular socket
on the OP
Contrast
adjustment
(on the rear)
0-004-7506-4 (EN), 11 (36)