t.a.c. Xenta OP Handbook page 14

TAC Xenta OP Handbook
5. National text
8. Display backlight controls the background light of the OP display.
1. Exit service mode means leaving the local OP service menu.
10. OP mode
14 (36), 0-004-7506-4 (EN)
Selecting the language of the OP messages
means that the operator can switch between different languages for
those messages that are generated in the OP.
Select language
No reply ...
Wait ...
Press Enter to save!
If you press or
German:
Select language
Keine Antwort ...
Bitte warten ...
Press Enter to save!
When you have selected a suitable language you press
("Enter") and then leave the menu.
Controlling the display light
There are three modes: OFF, ON and AUTO.
OFF means that the backlight is always turned off,
ON means that the light is turned on permanently and
AUTO means that the light is turned on as soon as a button is
pressed, but goes off about 30 minutes after the last key has been
pressed.
+
Use and – to select the required mode.
As the display light may cause loss of contrast if turned on perma-
nently, we recommend the AUTO or OFF mode.
Leaving the OP Service menu
This will also happen if no key has been used during about 40 seconds.
Selecting the OP mode
In TAC Xenta networks the OP may work in one of two
communication modes:
- for communication with Base units, TAC Xenta 300 and 400
- for communication with TAC Xenta 100
Furthermore, the OP can be more or less mobile, depending on the
way the OP is connected to the network.
Please refer to the next section!
2 Connection and Basic Functions
the language will change, for example into
TAC AB, 2001-08-08