Connecting To Tac Xenta 100 - t.a.c. Xenta OP Handbook

TAC Xenta OP Handbook

2.2 Connecting to TAC Xenta 100

Connecting the TAC Xenta OP to TAC Xenta 100 via the Wall Module
10 (36), 0-004-7506-4 (EN)
Normally the TAC Xenta OP is connected to the modular jack on the
lower side of the Wall Module. In this way the Xenta OP will get
power supply from the TAC Xenta 100 unit.
Cable between controller and Operator panel ...................... max. 10 m
Wall Module
The contrast of the display can be adjusted with the potentiometer on
the rear of the operator panel; please refer to the figure in the next
section.
2 Connection and Basic Functions
TAC Xenta 100
COMFORT
ECONOMY
OFF
TAC AB, 2001-08-08