t.a.c. Xenta OP Handbook page 16

TAC Xenta OP Handbook
Press enter to
access Xenta 100
(wait)
Connecting to
Xenta Base unit
OP Service menu
1. Exit service mode
2. Keyboard test
3. Display test
.
10 OP mode
Change OP mode
Xenta 100 : OFF
Bindable : TAC
1. Exit service mode
Bindable
16 (36), 0-004-7506-4 (EN)
To turn OFF the Xenta 100 mode
1 (Disconnect and then) connect the OP; wait for a couple of
seconds for the Base unit message to appear.
2 Press both keys
simultaneously.
3 Select 10.OP mode menu.
+
4 Press or
press .
5 Select the 1.Exit service mode menu and press
"Bindable" is a LonWorks term, describing how the OP is connected
and addressed in the network. This, in turn, affects the mobility of the
OP.
Use + or to select Bindable mode from the following.
–
• TAC OP movable. Two available addresses following each
TAC Xenta Base unit.
• INST OP permanently electrically connected to the network;
installed with a binding tool.
• MAN OP movable, the domain ID of the network has to be
programmed via
(communication is here limited to Base units on the same
channel).
For OP version 3.11 and earlier the following modes can be chosen.
• OFF OP movable. Two available addresses following each
TAC Xenta Base unit.
• ON OP permanently electrically connected to the network;
installed with a binding tool.
Confirm your choice by pressing
2 Connection and Basic Functions
. and for about three seconds
– to set the Xenta 100 mode OFF and
OP Service menu – 4.LON address
.
.
TAC AB, 2001-08-08