Initiate Service Pin Message - t.a.c. Xenta OP Handbook

TAC Xenta OP Handbook

3.5 Initiate Service pin message

22 (36), 0-004-7506-4 (EN)
Input variables appear further down in the list:
Example: Select NV 013 to get the Application Mode:
13 nviApplicMode
Auto
nvi indicates that this is an input value. The cursor is visible and
allows the value to be changed from the OP.
+ –
Use and
increase the toggling speed.
Press to enter the new value.
If or or
take place.
The keys and
list.
When the NV index selection is displayed
units as SI [^]
NV index? 000
a Service pin message is sent from the Xenta 100, initiated from the
OP, each time the
3 Dialogs with TAC Xenta 100
_
to change the value. Keep the key pressed to
is pressed before
will take you to the adjoining NVs in the
key is pressed.
, no change will
TAC AB, 2001-08-08