Automatic Data Importing From External Memory - King gates STARG8 24 Programming

After this procedure, if the memory is left connected to the PCB, the external memory will continue to be updated. If instead no changes
occur, such as the addition of transmitters or modifications to parameters, the memory can be removed.
17.2 -

Automatic data importing from external memory

This procedure allows for importing, from the external memory to the control unit, the transmitters and any settings activated through the
advanced programming.
To import the advanced settings in addition to the remote controls, the external memory must have been used on a control
unit that controlled the same type of motors as the new one (see dip-switch 1 and 2 settings – Paragraph 3.1).
If the control unit already includes transmitters, these will be maintained.
CUT OFF THE POWER SUPPLY TO
THE CONTROL UNIT
All the LEDs turn off
NO ACTION. BY LEAVING THE ME-
MORY ON THE CONTROL UNIT, IT
WILL ALWAYS UPDATED
POWER ON THE CONTROL UNIT
The yellow led SET flashes for 5
seconds. After that, all the LEDs go
back to regular operation
If before this procedure, the control has been set the same way of the previous one (i.e. by setting the dips 1-2 as in the
control unit from which you removed the memory card) this new control unit will import all the standard and advanced settings
(eg: Backjump, autotest...)
INSERT THE MEMORY MODULE
(Picture 12)
The LEDs are off
memory always synchronized inserted on the
REMOVE THE MEMORY (figure 12)
All the LEDs are off
POWER THE CONTROL UNIT
The red "radio" LED is turned on in the fixed mode
to signal the progress of the copying procedure
THE CONTROL UNIT RETURNS
TO THE NORMAL OPERATING
control unit
CONFIGURATION
The yellow led SET flashes for 5
seconds. After that, all the LEDs go
back to regular operation
Removing the
memory
POWER OFF THE CONTROL UNIT
All the LEDs turn off
13