Table of Contents
Advertisement
< Manual Scan
Scan through power -on computers one by one by keyboard control. Scan Type
(<F4>:More\Scan Type) determines if scanned computers must also be eye mark
selected. Press the up arrow key (↑) to select the previous computer and the down
arrow key (↓ ) to select the next computer.
Manual Scan mode.
< Audio Stick
An optional multimedia module can be LINKed to the back of each RMD-1150 for
selecting microphone and stereo speaker signals. There are two options for Audio
Stick: ON and Off. When set to 'On', audio selection follows computer selection.
When set to 'Off', audio selection stops following computer selection. It is useful if
you want to listen to a particular computer's audio signal while operating other
computers. The non-volatile memory stores the Audio Stick setting.
< Scan Type
Ready PC +N: In Scan mode, scan through power-on and eye mark selected
computers.
Ready PC: In Scan mode, scan through power-on computers.
The non-volatile memory stores the Scan Type setting.
< Scan Rate
Sets the duration of a computer displayed in Auto Scan mode. The options are 3
seconds, 8 seconds, 15 seconds and 30 seconds. The non-volatile memory
stores the Scan Rate setting.
< Keyboard Speed
RMD-1150 offers keyboard typematic setting that overrides the similar settings in
BIOS and in Windows. Available speed options are Low, Middle, Fast and Faster
as 10, 15, 20 and 30 characters/sec respectively.
The non-volatile memory stores the Keyboard Speed setting.
< Hotkey Menu
When you hit the left <CTRL> key twice within two seconds, the "Hotkey Menu"
appears displaying a list of hot-key commands if the option is On. The 'Hotkey
Menu' can be turned Off if you prefer not to see it when the left <CTRL> key is hit
twice.
The non-volatile memory stores the Hotkey Menu setting.
< CH Display
Auto Off: After you select a computer, the channel address and name of the
computer will appear on the screen for 3 seconds then disappear automatically.
Always On: The channel address and name of a selected computer and/or OSD
status displayed on the screen all the time.
The non-volatile memory stores the CH Display setting.
< Position
The position of the selected computer name and/or OSD status displayed on screen
during operation. The actual display position shifts due to different VGA resolution,
the higher the resolution the higher the display position. The non-volatile memory
stores the Position setting.
UL as Upper Left, UR as Upper Right,
Press any other key to abort the
12
Advertisement
Table of Contents
