Insert Label; Remove Label; Installation - Siemens QMX3.P30 Instruction Manual

Labels for QMX3.P02,
QMX3.P37

Insert label

Remove label

Installation

Caution!
QMX3... Wall-mounted sensors and room operator units for KNX PL-Link, KNX S-mode and KNX LTE-Mode
Siemens Building Technologies
54 ± 0.15
• For KNX PL-Link wiring (topology, allowed cables and cable length), see the
Desigo TRA installation guide, CM111043.
• Use the correct cables for the KNX PL-Link bus
• Do not interchange the wires of the KNX PL-Link cable.
– The red terminal is for KNX PL-Link +
– The gray terminal is for KNX PL-Link –
• For KNX S-mode follow the KNX regulations
• Observe all local installation regulations.
• The devices are not protected against accidental connection to AC 230 V.
Sample icons are available in the label
template M1602.1
Information. e.g. on room operator unit
location or on room type (free text)
7 / 16
CM2N1602en_07
2017-05-22