Wall Mounting; 4-Wire Cables; Cable Ducts On The Wall; Dismounting / Service - Siemens QMX3.P30 Instruction Manual

Wall mounting

Remove the breakout on the housing before putting the cable into the gaining channel.

4-wire cables

(daisy chain wiring)

Cable ducts on the wall

Dismounting / service:

6 / 16
QMX3... Wall-mounted sensors and room operator units for KNX PL-Link, KNX S-mode and KNX LTE-Mode
Siemens Building Technologies
30 mm
Remove the cable coating, as it will not fit in
the gaining channel.
Keep a distance of 30 mm (from above) /
20 mm (from below) to the base plate,
so that the device can be snapped onto the
base plate.
CM2N1602en_07
2017-05-22