Mounting Over A Conduit Box; Monting Over A Cavity Wall Box - Siemens QMX3.P30 Instruction Manual

Mounting over a
conduit box
*) The installing tube must be sealed or cold or warm air may enter the device and cause faulty
temperature readings by the internal sensor.
Monting over a cavity
wall box
The installing tube must be sealed or cold or warm air may enter the device and cause faulty
temperature readings by the internal sensor.
1 Fixing the box on the cavity wall.
2 Fixing the QMX3.MP1 base plate on the box using 2 screws.
3 The gray foam plate (removable) compensates for the jutting edge of the box so that the plate
is aligned with the wall.
QMX3... Wall-mounted sensors and room operator units for KNX PL-Link, KNX S-mode and KNX LTE-Mode
Siemens Building Technologies
Service LED (red) Tool plug
Use a metal-reinforced base plate QMX3.MP1 instead oft he standard base plate
delivered with the room operator unit.
1
2
2
1
Programming pin
3
5 / 16
CM2N1602en_07
2017-05-22