Timex Global Trainer M229 User Manual page 32

2. Press q to highlight POWER METER, then press 8 .
3. Press p or q to highlight the setting to change, then press 8 to open the setting change window.
4. Press p or q to highlight a selection in the setting change window, then press 8
selection.
Setting Group
Threshold Power
View
Zones
Minimum / Maximum
watts for zones 1
through 6
GPS
Configure options for the GPS, view device version information, and view satellites. You can also reset the
watch and update the firmware from this menu.
To Configure GPS Settings
1. Press MODE until CONFIGURE displays.
2. Press q to highlight GPS, then press 8 .
3. Press p or q to highlight the setting to change, then press 8 to open the.setting change window.
4. Press p or q to highlight a selection in the setting change window, then press 8 to confirm your selection.
Setting Group
GPS
WAAS / EGNOS
Speed / Pace Smooth
Altitude Smooth
Version
Press q to highlight VERSION, then press 8 to view the firmware version.
To upgrade the firmware:
1. While viewing the version screen, hold START/SPLIT for 2 seconds.
2. Press q to highlight YES or NO, then press 8 to confirm your selection. Select YES to upgrade the firmware,
or select NO to return to the version screen without upgrading.
3. When prompted, insert the large USB-A plug of the download/charging clip into a USB port on any computer,
then connect the download/charging clip to the back of the Global Trainer™ Bodylink® System Watch.
4. To back out of the firmware upgrade process, press ENTER and START/SPLIT at the same time. This will
power off the device.
Enter the threshold power in watts. The range is 0 to 600
Select watts or % of threshold
Select CUSTOM to enter watt ranges for each zone manually, or select USE MAX
to automatically calculate values.
Enter the minimum and maximum values for each zone. Press
ting change window. The minimum is 1. The maximum is 999. NOTE: You can only
change the zone values if Zones is set to CUSTOM.
Select OFF to turn the GPS system off. Select ON to turn the GPS system on. Set-
ting to off will increase battery life but workouts will not have positional or GPS
speed information.
Select OFF to use standard GPS positioning, which updates more quickly. Select
ON to enable WAAS/EGNOS, which is more accurate.
Select OFF to update speed and pace data more quickly. Select ON to apply a
filter to get more stable speed and pace data. NOTE: Smoothing reduces large
variations in data due to GPS fluctuation.
Select OFF to update altitude data more quickly. Select ON to apply an averaging
filter to get more manageable altitude data
30
Adjustment
8
Adjustment
to confirm your
to close the set-