Table of Contents
Advertisement
174
Exceptions
Image Position
The
feature enables you to change the location of
Image Position
the entire printed image on the sheet (simplex or duplex).
This function uses the following terminology:
•
the sheet's edge near the printer rear, where printing
Rear:
stops
•
the edge of a sheet at which printing begins
Lead:
The page's lead and rear edges are determined just after the page
is printed out, before making any change in the page orientation.
Select one of the following options:
To print your job in the center of the page, click
To set page offsets, enter
To apply page offset values to both odd and even pages, select
the
Same on both sides
Note: Use this option to move duplex page data away from the spine.
Exceptions are used when you want to use different media types
for special exceptions within a job or add inserts (interleaves).
Appendix A– Setting Parameters
and
Rear
Lead
check box.
.
Center
values.
Advertisement
Table of Contents
