Setting Parameters in the Job Parameters Window
You can adjust your page size by adjusting the trim size.
Note: If you set the trim size to be smaller than the page size set in the DTP
application, some of the data is cropped. Setting a larger trim size results in a
larger border on the printed page.
specifies the orientation, portrait or landscape, for
Trim orientation
the trim size. If the wrong orientation is specified, an unsuitable
template might be selected and the job might be cropped as a
result.
Templates
Category
In the
list, select the number of pages to place
1.
Columns
horizontally. The rows and columns indicate how the pages will
be placed on the sheet.
In the
list, select the number of pages to place vertically.
2.
Rows
Print method
Select the desired layout—for example,
.
HTT
North south
Select this check box if the template you chose is either step
and repeat 2×1 or 1×2. The pages will be placed 180 degrees
from each other, on the same side of the imposed sheet.
or
Duplex HTH
Duplex
161