172
Finisher Module
Tray
Select one of the following exit trays for your printed output:
•
Paper Exit tray:
•
Prints to the finisher's upper tray
Sub tray:
•
Prints to the finisher's stack tray
Main tray:
•
The
Offset
want to use an offset between sets, clear this check
box.
•
The
Staples
to position the staples on the page.
•
The
Punch
available. There are three punch units available, 2 hole,
3 hole , or 4 hole.
•
Prints to the booklet finisher
Booklet tray:
•
In the
Tray
booklets in the center of the page.
booklets in an accordion fold.
•
Select the
•
The
check box is active only when a trimmer unit is
Trim
available.
Note: If you want to staple or punch the other side of your job, select the
Rotate 180 check box on the Print Method parameter.
Print Order
Collated
Select this check box to print a complete copy of the job before
the first page of the next copy is printed.
Reverse print order
Select this check box to set the print order from back to front.
Appendix A– Setting Parameters
Use this option if a finisher is not connected.
check box is selected by default. If you don't
list enables you to specify where you want
check box is active only if a punch kit is
list, select the fold type.
check box if you want center staples.
Staples
folds your
Center Fold
folds your
3-Fold