Disassembly For Repair - Kenwood TK-5210G Service Manual

TK-5210
Disassembly Procedure
■ Removing the front case from the chassis
1. Remove the rear panel with a fl at-head screwdriver.
Insert the screwdriver between the rear panel (right side)
and the chassis (the place next to the " " mark shown
on the chassis), push it in the direction of the arrow q,
and remove the right side of the rear panel. Repeat the
above action for the left side of the rear panel w.
" " mark
Rear panel
2. Remove the four screws e and universal connector cap
r.
3. Lift the battery pack release latch on the bottom of the
chassis t and remove the chassis from the front case.
Note:
• Lift the chassis from the front case slowly and carefully.
If the chassis is lifted suddenly, the SP/MIC FPC may be
pulled and the connector may become damaged.
• Handle the main packing with care. It is likely to collect
dust and dirt.
4. Remove the SP/MIC FPC from the CONTROL PCB con-
nector (CN34) y.
Battery pack
release latch
12
( G )

DISASSEMBLY FOR REPAIR

" " mark
Chassis
CN34
SP/MIC FPC
Front case
■ Removing the CONTROL PCB (X53-439) from
the chassis
1. Remove the six screws u.
CONTROL PCB
2. On the reverse side of the CONTROL PCB i, remove
the cord ASSY and each FPC from the connectors (CN40,
CN35, CN38) of the CONTROL PCB.
CN35
CN40
Note:
Fold indications are printed on the Cord ASSY and Uni-
versal Connector FPC.
"- - - -" line shows creased line on the bottom.
Cord ASSY
Chassis
CN38
Cord ASSY