Adjustment - Kenwood TK-5210G Service Manual

Controls
Selector
Volume
Side 1 key
PTT switch
Side 2 key
Side 3 key
Panel Test Mode
(K2, K3 and K7 models only)
For the K model (without LCD), perform "Test mode" us-
ing the KPG-95DG.
■ Test mode operation features
This transceiver has a test mode. To enter panel test
mode, press and hold the [Side3] and [PTT] keys while turn-
ing the transceiver power ON and then the [PTT] key fi rst.
Test mode can be inhibited by programming. To exit test
mode, turn the transceiver power OFF.
• When the panel test mode is activated, the channel se-
lected with the [Selector] knob and the last used signal-
ing number are displayed. When it is activated for the
fi rst time, the signaling number is 1.
• If test signaling 26 (Tone Pattern) is selected, the result
of Bit Error Rate (BER) calculation is displayed on the
LCD. The BER value is also output from the serial port.
• The P25 and analog modes are switched automatically by
selecting test signaling. When P25 mode is effective, "A"
is displayed on the LCD.

ADJUSTMENT

Concentric Switch
Universal
connector
Lever switch
Orange key
TK-5210
• Key operation
Key Function
Test frequency channel
[Selector]
up/down
Channel spacing switching
[Concentric (Position "A": Wide,
switch] Position "B": Narrow,
Position "C": P25)
RF output power switching
[Lever
K
( : Low power,
switch]
●: High power)
[PTT] Transmit
Squelch level change
[Side1]
(0→1→2→...→9→0→1→2→...)
[Side1]
Squelch off
Hold
MSK baud rate change
[Side2]
(1200bps/2400bps)
[Side2]
Compander on/off
Hold
Shifts to the Panel tuning
[Side3]
mode
[Side3]
LCD all lights
Hold
[Orange] Beat shift on/off
[A] AFC on/off
[B] Unused
[C] Test signaling down
[D] Test signaling up
Use as the DTMF keypad.
[0] to [9] If a key is pressed during
and transmission, the DTMF
[#], [ ] corresponding to the key that
was presses is sent.
• LED indicator
Red LED Lights during transmission.
Blinks at the low battery voltage warning.
Green LED Lights when there is carrier.
( G )
Display
Channel No
Wide: "W"
Narrow: "N"
P25: "A"
Low power: "LO"
High power: "HI"
-
Squelch level 0:
"SQ.LV0"
Squelch level 1:
"SQ.LV1"
Squelch level 9:
"SQ.LV9"
2400bps:
icon appears
On: icon appears
-
LCD all point appears
On: icon appears
On: icon appears
-
Signaling No.
Signaling No.
-
45