Kenwood TK-5210G Service Manual page 15

■ Main Packing (G53-1637-04) Installation Procedure
1. Hook the packing (coated with silicon oil) in the upper
groove of the chassis q, then fit the packing into the
lower groove of the chassis w.
Note:
Ensure that the chassis grooves and packing are free
from dirt and dust.
2. Fit the packing into the grooves on both sides of the
chassis e. (Fit the packing into the groove in the chassis
by tracing it lightly with your fi ngers.)
Main packing
Note:
To remove the packing from the chassis groove, use a
resin adjustment bar or other such device. If the packing
is pried with a sharp metallic tool, such as tweezers, the
packing may become damaged.
3. Verify that the packing fi ts snuggly into the groove of the
chassis.
■ Top Packing (G53-1638-04) Installation Procedure
1. Ensure that the hardware fi xture is fi rst secured to the
chassis.
2. Hook the packing (coated with silicon oil) in the upper
left groove of the chassis q, then fi t the packing into the
right groove of the chassis w.
Hardware fixture
Note:
• Verify that the chassis grooves and packing are free from
dirt and dust.
• To remove the packing from the chassis groove, use a
resin adjustment bar or other such device. If the packing
is pried with a sharp metallic tool, such as tweezers, the
packing may become damaged.
DISASSEMBLY FOR REPAIR
Top packing
TK-5210
3. Verify that the packing fi ts snuggly into the groove of the
chassis.
■ Volume Torque-up Packing (G53-1628-04)
Installation Procedure
Insert the packing using a pair of tweezers so that the
hollow of the packing fi ts the convex of the panel q.
Volume torque-up packing
■ Screw sequence for mounting the battery
terminal block to the chassis
Attach the battery terminal block to the chassis as de-
scribed in the following procedure.
1. Loosely fi x the hexagon screws of the GND terminal to
the chassis (enough so that the hexagon screws do not
move).
2. Tighten the two screws from the TX-RX PCB side.
3. Firmly tighten the hexagon screws of the GND terminal.
( G
GND terminal
Two screws
15
)