Vertical Cut / Lawn Edge Trimming; Cleaning And Maintenance; Cleaning; General Maintenance - LawnMaster CLGT2425 Original Operation Manual

Cordless grass trimmer
Table of Contents

Advertisement

Vertical cut / lawn edge trimming

Be particularly careful and at
tentive when holding the cutting
disk vertically. To avoid injuries,
keep enough distance to the
trimming assembly.
Setup for vertical trimming:
Move the appliance to the right
and left in a slow swinging motion
to trim slopes and steep inclines.
• Handle rod: 180° (see
• Cutting angle: 0° (see
• Spacer bow in parking position
Setup for edge trimming:
To trim lawn edges, slowly move
the appliance along the lawn edges.
• Handle rod: 90° (see
• Cutting angle: 90° (see
• Spacer bow in parking position
Cleaning and
maintenance
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

Do not spray the appliance with wa-
ter and do not immerse it in water.
Electric shock hazard!
-
Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or sol-
vents. You may otherwise irreparably
damage the appliance.
After every trimming session, remove
)
grass and soil from the protective
)
cover and the trimming assembly.
To thoroughly clean the trimming as-
sembly, remove the cutting insert ( 13)
(see "Replacing the cutting insert") and
use a sharp knife to clean the pin ( 23).

General maintenance

)
)
Prior to every use, check the appli-
ance for obvious defects such as
loose, worn or damaged parts.
Check that the screws in the cutting
disk are tight.
Check covers and safety devices for
damages and correct installation. Re-
place as necessary.

Replacing the cutting insert

1. Slide the cutting insert (13) in-
ward and push it out of the pin
(23) on the cutting disk (12).
2. Place the new cutting insert (13)
on the pin (23) and pull out the
insert until it snaps in.

Storage

Store the trimmer in a dry place well
out of reach of children.
13
GB

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents