Electrolux EOB 3000 Instruction Booklet page 15

Oven Shelves and Shelf Supports
To clean the oven shelves, soak in warm soapy water and
remove stubborn marks with a
impregnated pad.
Rinse well and dry with a soft cloth.
The shelf supports can be removed for easy cleaning.
Proceed as follows:
1) remove the front screw while keeping the shelf support
in position with the other hand (Fig. 4);
2) disengage the rear hook and take off the shelf support
(Fig. 5);
1) once the cleaning is carried out, refit the shelf
supports following the procedure in reverse.
Please, ensure the retaining nuts are secure when
refitting the shelf support.
When cleaning the shelf supports, take care
not to remove the lubricating grease behind
the telescopic runners. This is meant to
ensure their good operation.
Replacing the Oven Light
Ensure the electricity supply is switched off
before carrying out this operation.
The oven bulb has to comply to these features:
a) resistant to temperatures of 300 °C;
b) electric rate: 230 V - 50 Hz;
c) electric power rate: 25 W;
d) connection type: E 14.
To replace the bulb, proceed as follows (Fig. 6):
a) push in and turn the glass lid anticlockwise;
b) remove tha faulty bulb;
c) replace it with a new one;
d) refit the glass lid;
e) switch on the electricity supply.
Grease Filter
When cooking meat, the grease filter must be fitted over
the oven fan by clipping it over the vents in the back
panel. This will prevent a built-up of fat on the fan
impellor. Do not use abrasive materials to clean the seal.
The grease filter is dishwasher proof.
When cooking is completed and the oven has cooled
down, remove the filter by pushing the protruding tongue
on the filter upward (see Fig. 7).
Wash the filter after use using warm soapy water.
Fit the grease filter only when roasting.
14
well wetted soap
Fig. 4
Fig. 5
Fig. 6
Fig. 7