Detailed Component Operating Instructions Intellifire™ Touch - Vermont Castings Radiance RADVT Series Installation & Operating Manual

K. Detailed Component Operating Instructions
- IntelliFire™ Touch
IFT-ECM Detailed Operating Instruction
This model is shipped from the factory equipped with the
IFT-RC400 remote.
1. The Electronic Control Module (IFT-ECM) has a three-
position ON/OFF/REMOTE selector switch that must
be set for proper operation, Figure 4.5. When changing
switch positions, it is important to pause in each position
for 1-2 seconds.
OFF Position:
The appliance will not respond to any commands from
a wired wall switch or IFT-RC400 remote controls. The
unit should be in the OFF position during service, fuel
conversion, and to reset the IFT-ECM in the event the
system goes into a LOCK-OUT mode as the result of a
system error. When switched to the OFF position while
the appliance is operating, the system will shut down.
ON Position:
The appliance will ignite and run continuously at the HI
flame setting. No adjustment in flame height is possible.
Remote Position:
The remote position allows operation of the appliance
from a wired wall switch or IFT-RC400 remote controls.
The IFT-ECM switch must be in this position to pair the
IFT-ECM with the IFT-ACM (if installed), and/or IFT-
RC400 remote controls. See the IFT-RC400 installation
manual for detailed instructions on pairing the IFT-ECM
with the remote controls.
After successfully pairing a IFT-RC400, all installed
accessories can be controlled by the IFT-RC400 (see
IFT-RC400 user manual). The IFT-ECM has a safety
feature that will automatically shut down the fireplace
after 9 hours of continuous operation without receiving a
command from the IFT-RC400.
The IFT-ECM has a safety feature that will
automatically shut down the fireplace after 9 hours
of continuous operation in the ON position, except
when operated in active thermostat mode.
2. If multiple control options are installed, the IFT-ECM will
respond to the last command from the wired wall switch
or IFT-RC400. The wired wall switch is NOT available if
a Power Vent is used.
3232 Vermont Castings • Radiance RADVT Installation Manual_R4 • 04/19
3. The Pilot button on the IFT-ECM activates the Cold
Climate function of the fireplace. This function lights the
pilot flame ONLY to provide enough heat in the firebox
to reduce condensation in cool, high humidity ambient
conditions. To activate the Cold Climate press and hold
the Pilot button for one second and release. The IFT-
ECM will flash two green LED blinks, beep twice and
light and rectify the pilot flame when pressed to activate.
To turn off Cold Climate, press and hold the Pilot button
for one second and release. The IFT-ECM will flash one
green LED blink, beep once and shut down the pilot
flame. If remote controls are paired with the IFT-ECM,
this feature can also be activated with the IFT-RC400.
3 Position Switch
LED Indicator
Figure 4.5 - IFT-ECM
DANGER
!
Risk of Explosion
DO NOT cycle the ON/OFF/REM selector switch
more than one time within a fi ve minute period.
Gas may accumulate in fi rebox. Call a qualifi ed
service technician.
Top View
3-90-30007498