KVH Industries TracVision HD7 Installation Manual page 27

B
Continued
Set Up Each Receiver/DVR
Follow the steps below to configure non-SWM
receivers/DVRs.
DISH Network and Bell TV Receivers/DVRs
Follow the steps below to run one Check Switch
test on each connected receiver and DVR.
NOTE: Once the receivers/DVRs are set up, you can
switch satellites as needed using the ACU front panel
buttons, web interface, or the KVH TracVision HD7
iPhone/iPod touch app.
a. Ensure the antenna has an unobstructed view
of the sky.
b. Using the receiver's remote control (and a
connected television), go to the "Point Dish/
Signal Strength" screen (press MENU, 6, 1, 1
on most receiver models).
c. Choose Check Switch, then press SELECT.
d. Choose Test (DISH Network) or Check
(Bell TV), then press SELECT.
e. Wait up to 10 minutes for the test to complete
and the receiver's Program Guide to load.
Once complete, the Check Switch displays
the current satellite, followed by "OK."
f. Using the receiver's remote control, select the
Program Guide to ensure it has loaded
properly.
DIRECTV Latin America and Legacy Non-SWM
DIRECTV Receivers/DVRs
g. Using the receiver's remote control (and a
connected television), set the Satellite DISH
Type to "Round." If you are configuring a
legacy DIRECTV receiver, be sure to also
choose "Multiswitch."
Configuring Non-SWM Receivers
27