Configure Swm Receivers/Dvrs - KVH Industries TracVision HD7 Installation Manual

Configure SWM Receivers/DVRs

14
Follow the steps below to start up the TracVision
system and configure each DIRECTV SWM
receiver and/or DVR for TracVision use.
IMPORTANT!
If you need to configure non-SWM devices,
such as DIRECTV Latin America, DISH
Network, Bell TV, or legacy DIRECTV
receivers, refer to "Configuring Non-SWM
Receivers" on page
Turn On the TracVision System
a. Apply power to the power inserter and ACU.
b. Press the power button on the front of the
ACU to turn on the TracVision system (see
Figure 28).
c. Wait for the Tracking screen to display on the
ACU (see Figure 28). This indicates system
startup is complete. It might take up to three
minutes.
d. Plug in and turn on any connected receivers,
DVRs, and televisions.
Set Each DIRECTV SWM Receiver/DVR to
Dish Type: Slimline-3
a. Press the Menu button on the receiver's/
DVR's remote control to display its menu on
the connected television.
NOTE: Refer to your selected receiver/DVR manual
for specific configuration instructions.
b. At the Satellite Dish Setup menu, set the Dish
Type to Slimline-3. Then choose Continue
(see Figure 29).
c. Repeat this procedure for each connected
receiver and DVR.
26.
Figure 28 ACU Tracking Screen and Power Button
T R A C K I N G S A T S
D I R E C T V 9 9 - 1 0 1 - 1 0 3
T R A C K I N G
® D I R E C T V 9 9 / 1 0 1 / 1 0 3
CONTROL UNIT MENU CHANGE
ANTENNA
POWER
Power
Button
Figure 29 DIRECTV SWM Receiver/DVR Configuration
Satellite Dish Setup
DIRECTV
Choose your dish configuration settings
Dish Type: 03: Slimline-3
Switch Type: 01: SWM
Do not install B-Band Converters.
!
S A T S
ACCEPT EXIT
setup
DISH AZIM. ELEV. TILT
SL3: 257˚ 36˚ 11˚
Continue
Dish Pointing
Signal Strength
Restore Settings
Cancel
17