Remove The Hatch And Radome - KVH Industries TracVision HD7 Installation Manual

5

Remove the Hatch and Radome

Remove the Service Hatch and Radome
Follow the steps below to remove the service
hatch and radome.
a. Using a #2 Phillips screwdriver, remove the
eleven M4 screws securing the service hatch
to the antenna's baseplate (see
the hatch aside in a safe place.
b. Using a #2 Phillips screwdriver, remove the
eight #10-32 Phillips screws securing the
radome to the baseplate (see
c. Carefully lift the radome straight up off the
antenna. Then set it aside in a safe place.
TIP: If you keep the radome topside, secure it with a
lanyard to prevent it from falling overboard.
Figure 8 Service Hatch Screws
Figure 8). Set
Figure 9).
Figure 9 Radome Screws
#10-32
Screw (x8)
Baseplate
Service Hatch
M4 Screw (x11)
Radome
7