Connect To An Onboard Network - KVH Industries TracVision HD7 Installation Manual

15

Connect to An Onboard Network

Follow these steps to either connect the
TracVision system to an existing onboard
network or install the supplied wireless router to
set up and connect to a new onboard network.
Connect to An Existing Network
By default, the ACU's Ethernet port is configured
as a DHCP client, which means the vessel's router
can automatically assign it an IP address when
connected to the ACU's Ethernet port (see
Figure 30).
NOTE: As an alternative, instead of using DHCP,
you may assign a static IP address to the ACU. See
"Change Network Settings" on page
Create a New Network
Follow the instructions below to create a new
onboard network using the supplied wireless
router (see Figure 30).
a. Mount the router in a cool, dry, well-
ventilated area belowdecks away from any
heat sources or salt spray. Also be sure the
location provides adequate Wi-Fi reception.
Do not install it in an area surrounded by
metal or near any electrical devices that emit
RF noise.
b. Connect an Ethernet cable from one of the
four numbered "Ethernet" ports on the
wireless router to the "Ethernet" port on the
ACU.
c. Connect a PC or mobile device to the wireless
router's default SSID network name
(Linksys<last 5 digits of the router's serial
number>.
d. Open the web browser and enter 192.168.1.1.
e. Follow the router's setup wizard to complete
installation.
IMPORTANT!
When setting up a wireless network, KVH
recommends applying security settings, such
as encryption, to protect your network from
outside intrusion. If your network is not
secure, outsiders within range of your
wireless network will be able to use your
wireless connection without your knowledge.
18
Figure 30 Network Connection Options
FUSE
3.15A
250V~
FAST ACTING
Vessel Network
20.
Ethernet
ANTENNA
ETHERNET RS232
AC INPUT
100-240V~
160W MAX
50/60 HZ
This device complies with Part 15 of the FCC rules. Operation is subject
CAUTION to the following two conditions: (1) This device must not cause harmful
interence, and (2) This device must accept any interference received,
RISK OF ELECTRIC SHOCK
DO NOT OPEN including interference that may cause undesired operation.
OR
Wireless Router
Optional
ACU
Tested to comply
Wi-Fi
with FCC Standards
Meets requirements
KVH and TracVision are registered
trademarks of KVH Industries, Inc.