Operating From The Remote Control; Swing Button - DeLonghi EX Series Instructions For Use Manual

To correctly set this mode:
• Touch the MODE key until the fan
• Select the desired fan speed by touching the key
The speeds available are:
Minimum speed: when maximum silent operation is
desired.
Medium speed: when the noise level needs to be
low but with a good fan level.
Maximum speed: for maximum fan power.
SELECT THE TEMPERATURE SCALE
The temperature can be displayed in °C or °F.
To change the temperature unit of measure touch both keys "+"
and " -" for about 10 sec.

OPERATING FROM THE REMOTE CONTROL

USING THE REMOTE CONTROL
• Point the remote control at the receiver (A11) on the air
conditioner. The remote control must be no more than 16
ft (5 metres) away from the appliance (without obstacles
between the remote control and the receiver).
• The remote control must be handled with care. Do not drop
it or expose it to direct sunlight or sources of heat.
max 16 ft
max 5 m
NOTE: The remote control can be safely stored in the appropriate
compartment A12 (see figure).
symbol appears.
DESCRIPTION OF THE REMOTE CONTROL
D1) ON/STAND-BY button
D2.1)Temperature decrease / programmed operation button
.
D2.2)Temperature increase / programmed operation button
D3) MODE function button
D4) Fan speed selection button
D5) Swing button (flap swing)
D6) Timer button
D3
D2.2
D6
TURNING THE APPLIANCE ON
• Plug into the outlet.
• Press the
ditioner starts operating in the same mode as when it was
turned off) .
• To switch the appliance off, press button (D1)
remove the plug.
NOTE: Never switch the appliance off by removing the plug.
Always switch it off by pushing on the
few minutes before removing the plug. Only in this way the ap-
pliance will perform the standard checkings.
SELECTING THE OPERATING MODES
The commands available on the remote control correspond to
those on the appliance control panel (C).
Therefore, refer to the instructions in the previous chapters.
NOTE: The special functions D5-D6, are available from the re-
mote control only.

SWING BUTTON

The SWING button (D5) moves the grille flap, evenly distributing
the air into the room.
When the SWING button is pressed, the flap will begin to move
forwards and backwards alternatively.
If pressed again, the flap will be locked into its current position.
When the button is next pressed, the flap will start to move
forwards and backwards again.
9
button (D1) (when turned on, the air con-
button and waiting
D1
D4
D2.1
D5
, then