Table of Contents
Advertisement
Available languages
Available languages
DEHUMIDIFYING MODE
This is ideal for reducing humidity in
the room (spring and autumn, damp
rooms, rainy periods, etc). For this
type of use, the appliance must be
set up same as in the air conditioner
mode. That is, the air exhaust hose
(B2) must be fitted to the appliance to
allow the humidity to be discharged
outside.
To correctly set this mode:
•
Touch repeatedly the MODE key (C2) until the dehumidify-
ing symbol appears.
•
The appliance will automatically choose the best air flow.
FAN MODE
•
Select the desired air flow by touching
The air flows available are:
Minimum air flow: when quiet operation is de-
sired.
Medium air flow: when the noise level needs to
be low but with a good comfort level.
Maximum air flow: for maximum performance.
SELECT THE TEMPERATURE SCALE
When using this mode, the air ex-
haust hose (B2) does not need to be
attached to the appliance.
To correctly set this mode:
• Touch repeatedly the MODE
(C2) key until the fan
bol appears.
button (C5).
The temperature can
be displayed in °C or °F.
To change the temper-
ature unit of measure
touch both the in-
crease
(C3) and
decrease
C4) keys
for about 10 seconds.
OPERATING FROM THE REMOTE CONTROL
INSERTING OR REPLACING THE BATTERIES
•
Remove the cover on the rear of the remote control;
•
Insert or replace the batteries with two new LR03 "AAA"
1.5V batteries, inserting them correctly (see the directions
inside the battery compartment) (fig. 7);
•
Replace the cover.
BATTERY WARNINGS
•
Always purchase the correct size and grade of battery most
suitable for the intended use.
sym-
•
When batteries of different brand or type are used togeth-
er, or new and old batteries are used together, some batter-
ies may be over-discharged due to a difference of voltage
or capacity. This can result in venting, leakage, and rupture
and may cause personal injury
•
Always replace the whole set of batteries at one time, tak-
ing care not to mix old and new ones, or batteries of differ-
ent types.
•
Clean the battery contacts and also those of the device prior
to battery installation.
•
Ensure the batteries are installed correctly with regard to
polarity (+ and -).
•
Remove batteries from product during periods of non-use.
Battery leakage can cause corrosion and damage to this
product.
•
Remove used batteries promptly.
For recycling and disposal of batteries to protect the environ-
ment, please check the internet or your local phone directory for
local recycling centers and / or follow local government regu-
lations.
USING THE REMOTE CONTROL
•
Point the remote control at the receiver no more than 7
meters (23 feet) away from the appliance (fig. 7) without
obstacles between the remote control and the receiver.
•
The remote control must be handled with care. Do not drop
it or expose it to direct sunlight or sources of heat.
9
max
7 meters/23ft
7
Advertisement
Table of Contents
