Table of Contents
Advertisement
Available languages
Available languages
To correctly set this mode:
•
Press repeatedly the MODE (C2) key until the fan
indicator appears.
•
Press repeatedly the
flow.
The air flows available are:
Minimum air flow: when maximum quiet operation
is desired.
Medium air flow: when the noise level needs to be
low but with a good comfort level.
Maximum air flow: for maximum performance.
SELECTING THE TEMPERATURE SCALE
The temperature can be displayed in °C or °F.
To change the temperature unit of measure select the air con-
ditioning mode then press both the decrease
crease
(C4) keys at the same time for about 3 seconds. You
must follow these steps on both the unit itself AND the remote
control.
SETTING THE TIMER
The timer allows the delayed start up or shut down of the appli-
ance. This function will prevent wasting electricity by optimizing
the operating periods.
How to program delayed shut down
•
While the appliance is on in any operating mode, delayed
shut down can be programmed.
•
Press the Timer button (C6): the timer indicator
and hours light up.
•
Use the buttons
(C3) or
hours until the appliance should shut down.
A few seconds after the timer is set, the setting is acquired, the
display shows the operating mode and the timer symbol stays
lit. At the pre-set time, the air conditioner goes into standby.
To cancel the timer program, press the timer button (C6) twice.
The timer indicator (C8) will go off.
How to program delayed start up
•
Plug in the appliance and set to stand-by.
•
Press the timer button (C
and hours light up.
•
Set with the buttons
(C5) key to select the desired air
(C3) and in-
C11
C15
C8
C10
(C4) to set the number of
C14
C3
C2
6):
the timer indicator (C8)
(C3) or
(C4) the number after
which you want the appliance to start to operate.
•
The appliance will start to operate in the same operating
mode that was previously set.
Start up can be programmed at any time within the next 24
hours that follow. A few seconds after the timer is set, the setting
is acquired. The timer indicator stays lit and the display returns
to standby. To cancel the timer program, press the timer button
(C6) twice. The timer indicator (C8) will go off.
OPERATION USING THE REMOTE CONTROL
•
Aim the remote control at the receiver (A12) on the air con-
ditioner. The maximum distance between the remote con-
trol and the appliance is 23ft/ 7 metres (with no obstacles
between the remote and the receiver).
•
The remote control should be handled with extreme care,
without dropping it or exposing it to direct sunlight and
keeping it away from heat sources.
OPERATING FROM THE REMOTE CONTROL
INSERTING OR REPLACING THE BATTERIES
•
Remove the cover on the rear of the remote control;
•
Insert or replace the batteries with two new LR03 "AAA"
1.5V batteries, inserting them correctly (see the directions
inside the battery compartment) (see figure 7);
•
Replace the cover.
C5
C6
C7
(C8)
C9
C12
C13
Please note: If the remote control unit is replaced or discarded,
the batteries must be removed and disposed of in accordance
with current legislation as they are harmful to the environment.
C4
Do not mix old and new batteries. Do not mix alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries. Do
not dispose of batteries in fire. Batteries may explode or leak.
C1
If the remote control is not be used for a certain length of time,
remove the batteries.
9
23ft/7m
7
Advertisement
Table of Contents
