Operating From The Control Panel - DeLonghi EX Series Instructions For Use Manual

OPERATING FROM THE CONTROL PANEL

TURNING THE APPLIANCE ON/OFF
Before plugging the appliance check the cap on back of
the unit are correctly inserted on drainage hose A10
Insert the plug in the socket. Two dashes appear on the display
indicating that the appliance is in stand-by.
Touch the (C1) key to turn on the appliance.
The flap A1 will open after few seconds.
When the appliance comes on, the last function set before it was
shut off is activated.
NOTE: If start-up is not continued, after a few minutes the
display light dims in order to reduce energy consumption.
To turn the appliance off, touch the
plug.
NOTE: Never turn off the air conditioner by simply pulling the
plug. Touch the key in order to put your air conditioner in
stand-by and wait a few minutes before pulling the plug. In this
manner, the appliance can perform the operating status checks.
AIR CONDITIONING MODE
This is ideal for hot and humid weather when the room needs to
be both cooled and dehumidified.
To correctly set this mode:
• Touch the MODE key until the air conditioning symbol ap-
pears. The display will show the desired temperature.
• To change the temperature to be reached, touch the + (C3)
key or the - (C4) key.
• Select the desired fan speed by touching the
The speeds available are:
Minimum speed: when maximum silent operation is
key and then pull the
key.
8
desired.
Medium speed: when the noise level needs to be
low but with a good comfort level.
Maximum speed: to reach the desired tempera-
ture as soon as possible.
The appliance automatically chooses the best fan
speed based on the temperature selected and the environmen-
tal conditions.
The most suitable temperatures during the summer range from 75
to 81°F. However, setting the temperature significantly lower than
the outdoor temperature is not recommended.
DEHUMIDIFYING MODE
This is ideal for reducing humidity in the room (spring and au-
tumn, damp rooms, rainy periods, etc. For this type of use, the
appliance must be set up as for air conditioner mode. That is, the
air exhaust hose (B2) must be fitted to the appliance to allow the
humidity to be discharged outside.
To correctly set this mode:
• Touch the MODE key until the dehumidifier symbol ap-
pears.
• The appliance automatically chooses the best fan speed.
FAN MODE
When using this mode, the air exhaust hose (B2) does not need
to be attached to the appliance.