Operating From The Remote Control - DeLonghi PAC ES Instruction Manual

To cancel the timer program, press the timer button (C6) twice.
The timer indicator (C8) will go off.
How to program delayed start up
• Set the appliance to standby.
• Press the timer button (C6): the timer symbol (C8) and
hours light up.
• Use buttons (C3) or
after which the appliance should start to operate.
• The appliance will start to operate in the same operating
mode that was previously set.
Start up can be programmed at any time within the 24 hours
that follow. A few seconds after the timer is set, the setting is
acquired. The timer indicator stays lit and the display returns to
standby.
To cancel the timer program, press the timer key (C6) twice. The
timer indicator (C8) will go off.
OPERATION USING THE REMOTE CONTROL
• Aim the remote control at the receiver (A12) on the air
conditioner. The maximum distance between the remote
control and the appliance is 7 metres (with no obstacles
between the remote and the receiver) (Fig. 5).
• The remote control should be handled with extreme care,
without dropping it or exposing it to direct sunlight and
keeping it away from heat sources.
MAX

OPERATING FROM THE REMOTE CONTROL

INSERTING OR REPLACING THE BATTERIES
• By means of a screwdriver unscrew the screw positioned on
the remote control back side and then remove the cover;
• Insert or replace the batteries with two new LR03 "AAA"
1.5V batteries, inserting them correctly (see the directions
inside the battery compartment) (Fig. 6);
• Replace the cover and fix it by means of the screw.
Please note: If the remote control unit is replaced or discarded,
the batteries must be removed and disposed of in accordance
with current legislation as they are harmful to the environment.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
Do not dispose of batteries in fire. Batteries may explode or leak.
(C4) to set the numbers of hours
7m
If the remote control is not be used for a certain length of time,
remove the batteries.
DESCRIPTION OF THE REMOTE CONTROL
D1. ON/STAND-BY button
D2. MODE button
D3. Fan speed selection button
D4. Increase button
D5. Decrease button
D6. Timer button
D1
C11
C15
C8
D5
C10
D6
C14
C11
C15
C8
C10
C3
TURNING THE APPLIANCE ON/OFF
C14
• Plug into the outlet.
C2
• Press the
the air conditioner starts operating in the same mode as
when it was turned off.
• To switch the appliance off, press the
C3
ton (D1) again.
Please note: Never switch the appliance off by removing the plug.
C2
Always switch it off by pressing the
and waiting few minutes before removing the plug. Only in this
way the appliance will perform the standard checkings.
SELECTING THE OPERATING MODES
The operating modes available on the remote control through
the MODE button (D2) correspond to those on the appliance
control panel (C).
SELECTING THE TEMPERATURES
In air conditioning mode press (D4) or
the desired temperature.
15
D2
C5
C6
D3
C7
D4
C9
C11
D7
C15
C12
C8
C10
C13
C14
C4
C1
ON/STAND-BY button (D1). When turned on,
C3
C2
ON/STAND-BY button (D1)
D
C5
C6
C7
C5
C9
C6
C7
C12
C9
C13
C12
C13
C4
C1
ON/STAND-BY but-
C4
C1
button (D5) to select