Network Interface Adapter Prerequisites; Wifi Interface Card - Toshiba SureMark 4610 2CR Hardware Manual

Figure 6. WiFi interface card
Device
N
O
P
Q

Network interface adapter prerequisites

The network interface adapters (Ethernet and WiFi) have dependencies on the level of the
printer and printer firmware.
• The printer manufacturing date must be later than June 10, 2013. The main logic card of
printers built prior to June 10, 2013 will not support these adapters. The manufacturing date
is located on the bottom of the printer.
• Firmware level 14 and higher is required for an Ethernet interface adapter.
• Firmware level 18 and higher is required for a WiFi interface adapter. Some older versions of
firmware will enable basic function, but that function will not match the function described in
this manual. These firmware levels will print a message, as part of a test receipt, that indicates
the firmware should be upgraded.
Note: The required firmware levels will not allow back-leveling to a version that does not fully
support the installed adapter.
If a network interface adapter is installed in a printer that has back level firmware or a main logic
card that does not support it, the printer indicates an error:
• The ready light will blink amber and the internal LED#2 will be lit, which indicates that the
printer firmware is back level. If the firmware is known to be at the minimum level identified,
then this condition indicates a failed adapter or other hardware problem,
20
4610 Hardware Guide for Models 2CR and 2NR
N
Q O
Description
WiFi antenna
Power supply
Cash drawer
WiFi indicator light
P