Paper Roll Placement - Toshiba SureMark 4610 2CR Hardware Manual

1.
Press and release the blue release button (
2. If necessary, remove any unused paper or empty paper roll cores from the paper roll bucket
before inserting a new paper roll.
Note: Refer to the label inside the rear wall of the printer for a diagram of how to load
paper.
Figure 20. Paper roll placement
3. Place the paper roll into the paper roll bucket with the leading edge of the paper coming
from the bottom of the roll, as shown in Figure 20.
Note: The thermal printhead will not print on paper with glue on it. If the new paper roll
was sealed by glue, tear off the 6 to 8 inches of paper with glue on it before loading it.
4. Close the paper cover.
5. Press the customer receipt feed button to advance the paper about 30 cm (about 1 ft.) to test
for proper feeding and correct alignment.
6. Tear off excess paper.
Attention: Do not pull the receipt paper out of the printer with the paper access cover closed.
This disengages the paper feed. The paper feed motor must then catch up before the printer can
feed the paper, which causes missing lines or partial lines of print. Use the customer receipt feed
button to advance the receipt, and all lines will print.
Supported paper types
The type of paper required for the 4610 is dependent on the printer model. The 4610 Models 2CR
and 2NR printers require paper that supports both thermal and impact printing.
Attention: Using an inferior grade of paper can affect the print quality, printhead life expectancy,
and printer mechanisms.
40
4610 Hardware Guide for Models 2CR and 2NR
in Figure 19) to release the paper door.
P