Connecting The Power Adapter And The Power Cord - Toshiba TEC B-SV4D-QM Owner's Manual

2. PRINTER SETUP
2.5 Connecting the
Power Adapter and
the Power Cord
NOTES:
1. Since the power cord is not
enclosed in this printer,
please purchase a proper one
after referring to page 1-2.
2. The EA10953 AC adapter
should be exclusively used for
the B-SV4D-QM Series
printer. The B-SV4D-QM
Series printer must be
powered by the EA10953 AC
adapter.
1. Make sure that the printer power switch is in the OFF (O) position.
2. Insert the Power Cord into the inlet of the Power Adapter.
Power Cord
3. Insert the Power Adapter connector into the Power Jack on the rear of
the printer.
Power Adapter Connector
4. Plug the other end of the Power Cord into a grounded outlet as shown
in the figure below.
E2- 4
ENGLISH VERSION EO1-33035

2.5 Connecting the Power Adapter and the Power Cord

Power Adapter
Power Jack