Fantech VLT 2800 Series Instruction Manual page 84

3. Release Internal Floating Points from point
address (NPA) 0 to 255.
4. Release Internal Integer Points from point
address (NPA) 0 to 255.
5. Release Internal Byte points from point
address (NPA) 0 to 255.
Description of choice:
Set the required time.
561 Protocol
(PROTOCOL)
Value:
FC protocol (FC PROTOKOL)
Metasys N2 (METASYS N2)
Function:
There is a choice of two different protocols.
Description of choice:
Select the required control word protocol.
For further information about using the Metasys
N2 Protocol see MG91C1XX.
580-582 Defined parameters
(DEFINED PNU'S)
Value:
Read only
Function:
The three parameters hold a list of all the parameters
that are defined in the VLT 2800. It is possible to read
single elements of the list by using the corresponding
subindex. The subindexes start at 1 and follow
the order of the parameter numbers.
Each parameter holds up to 116 elements
(parameter numbers).
When a 0 is returned as parameter number the list ends.
= factory setting. () = display text [] = value for use in communication via serial communication port
MG.28.A8.22 - VLT is a registered Danfoss trademark
VLT® 2800 Series
[1]
[2]
83