Fantech VLT 2800 Series Instruction Manual page 33

004 Active Setup
(ACTIVE SETUP)
Value:
Factory Setup (FACTORY SETUP)
setup 1 (SETUP 1)
setup 2 (SETUP 2)
Setup 3 (SETUP 3)
setup 4 (SETUP 4)
Multi Setup (MULTI SETUP)
Function:
The active parameter Setup is selected here. All
parameters can be programmed in four individual
parameter Setups. Shifts between Setups can
be made in this parameter via a digital input
or via serial communication.
Description of choice:
Factory Setup [0] contains the factory-set parameter
values. Setup 1-4 [1]-[4] are four individual
Setups which can be selected as required. Multi
Setup [5] is used where remote-controlled shifts
between the four Setups via a digital input or via
serial communication is required.
005 Programming Setup
(EDIT SETUP)
Value:
Factory Setup (FACTORY SETUP)
Setup 1 (SETUP 1)
Setup 2 (SETUP 2)
Setup 3 (SETUP 3)
Setup 4 (SETUP 4)
Active Setup (ACTIVE SETUP)
Function:
You can select which Setup you want to program
during operation (applies both via the control panel
and the serial communication port). It is, for example,
possible to program Setup 2 [2], while the active Setup
is set to Setup 1 [1] in parameter 004 Active Setup .
Description of choice:
Factory Setup [0] contains the factory-set data and can
be used as a source of data if the other Setups are to be
reset to a known status. Setup 1-4 [1]-[4] are individual
Setups that can be programmed freely during operation.
If Active Setup [5] is selected, the programming Setup
will be equal to parameter 004 Active Setup.
= factory setting. () = display text [] = value for use in communication via serial communication port
32
VLT® 2800 Series
NOTE
If data is modified or copied to the active
Setup, the modifications have an immediate
[0]
effect on the unit's operation.
[1]
[2]
006 Setup copying
[3]
[4] (SETUP COPY)
[5]
Value:
No copying (NO COPY)
Copy to Setup 1 from #
(COPY TO SETUP 1)
Copy to Setup 2 from #
(COPY TO SETUP 2)
Copy to Setup 3 from #
(COPY TO SETUP 3)
Copy to Setup 4 from #
(COPY TO SETUP 4)
Copy to all Setups from # (COPY TO ALL)
Function:
You can copy from the selected active Setup in
parameter 005 Programming setup to the selected
Setup or Setups in this parameter.
NOTE
Copying is only possible in Stop (motor stopped
in connection with a stop command).
Description of choice:
[0]
Copying begins when the required copying function
[1]
has been selected and the [OK]/[CHANGE DATA]
[2]
key has been pushed. The display indicates
[3]
when copying is in progress.
[4]
[5]
007 LCP copy
(LCP COPY)
Value:
No copying (NO COPY)
Upload all parameters (UPL. ALL PAR.)
Download all parameters (DWNL. ALL PAR.)
Download size-independent parameters
(DWNL.OUTPIND.PAR.)
Function:
Parameter 007 LCP copy is used if you want to use
the LCP 2 control panel's integral copy function. The
function is used if you want to copy all parameter
MG.28.A8.22 - VLT is a registered Danfoss trademark
[0]
[1]
[2]
[3]
[4]
[5]
[0]
[1]
[2]
[3]