Online Measurement; Achieving An Online Connection; Set Up The Pc For Access - Bosch M 60 Manual

11 | Online Measurement

11.1 Achieving an online Connection

11.1.1 Set up the PC for Access

70 / 104
11 Online Measurement
M 60 configuration
– System configuration (channel configuration, CAN I/O, PWM Out, etc.) is stored in the
M 60.
– Use RaceCon to create and download configuration from the PC to M 60
– Communication interface: Ethernet
– Communication protocol: XCP
Online measurement and calibration
– System status and diagnosis
– Check and calibrate sensors in the vehicle.
– Live display of sensor values on the PC
– Use RaceCon for diagnosis, online measurement and calibration.
– Communication interface: Ethernet
– Communication protocol: XCP
This chapter describes how to set up the PC for access, going online and how to update
the firmware.
1. Switch off local firewall on the PC.
2. Set IP Configuration for the Ethernet interface to 'automatic configuration' (DHCP).
See chapter Setting up the Network Interface [} 16] for details.
3. Start RaceCon.
4. Establish the Ethernet connection to the vehicle.
5. Power on the vehicle.
6. Click 'OK' to download RaceCon configuration to device.
Modular Sensor Interface M 60 Bosch Motorsport