Bosch M 60 Manual page 32

8 | Math and Condition Channels
32 / 104
a) Enter the name of the condition channel.
b) Select the comparing mode:
• Constant: Compare a measurement channel with a constant value.
• Channel: Compare a measurement channel with a measurement channel.
• Range: Compare a measurement channel with a defined value range.
• Multiple: Compare a measurement channel with up to 5 constant values.
c) Depending on the chosen comparing mode, you can enter the following
values:
• Constant: Choose the measurement channel or condition, the operator and
enter the value of the constant.
• Channel: Choose the measurement channel or condition, the operator and
the measurement channel or condition to becompared.
• Range: Choose the measurement channel or condition, the operator and
define the minimum and maximum value.
• Multiple: Choose the measurement channel or condition, the operator and
enter the value of up to 5 constants.
d) Enter the minimal time to detect the signal of the measurement channel to
avoid high-frequent switchovers.
e) Enter the time the signal of the measurement channel is delayed after its
ending.
f) Choose the output setting of the result.
• Constant TRUE/FALSE: Result is as a constant with the value TRUE or FALSE.
• Blinking: Result is a blinking if the condition is fulfilled.
• Pulse: Result is a short one-time pulse if the condition is fulfilled.
• Toggling output: Result is a pulse that lasts until the next condition is fulfilled.
The conditional channel is displayed in the M 60 condition channel window.
Modular Sensor Interface M 60 Bosch Motorsport