Bosch M 60 Manual page 23

Starting up | 7
3. Assign the desired mounting location (e.g. 'Front') and confirm by clicking 'Apply'.
The mounting location is now stored in the device. The device will do a reset and the
'RUN' LED on the device will change to green. The list will show the new mounting
location assignment.
It is good practice to physically label the M 60 with its mounting location.
Now the device is ready to be used.
A different coloring of the M 60 is used to indicate that the device is already con-
figured in the currently loaded RaceCon project or not (white/orange).
A conflict of several connected M 60 using the same location is indicated by red col-
oring the involved devices:
Bosch Motorsport Modular Sensor Interface M 60 23 / 104