Assign The Mounting Location - Bosch M 60 Manual

Bosch Motorsport
RaceCon detects configuration differences between the M 60and the RaceCon project
and asks for permission for data download.
8. Click 'OK' to proceed.
The download starts and the M 60 carries out a reset. After the reset RaceCon reconnects
to the M 60. Local configuration on both the PC and M 60 match (indicated by green
background and dot). The M 60 is now connected to RaceCon.

7.2 Assign the Mounting Location

Because up to eight M 60 can be used in one network for I/O expansion, the mounting
location is used for determination between the different M 60.
At delivery no mounting location is set. This is signaled by an orange 'RUN' LED on the
device. Therefore one must first assign a mounting location to the M 60 before it can be
used in the project. The mounting location is permanently saved in the M 60. If necessary
you can at any time reassign a different mounting location following the same procedure.
A mounting location must not be used several times in one network, this would disturb
the functionality of the respective M 60.
Modular Sensor Interface M 60
Starting up | 7
21 / 104