Table of Contents
Advertisement
Simrad ES38-18/200-18CR Installation Manual
9
Seal the top of the steel conduit with a Roxtec (or similar) multi-diameter cable
sealing.
Related topics
12-pin Amphenol plug, page 39
Connecting the transducer to the other transceivers, page 40
Mounting the transducer
When all the preparations have been made, observe this procedure for the mounting of
the transducer If required, additional and more detailed procedures must be provided by
the installation ship yard.
Prerequisites
The following requirements must be met before mounting the transducer:
• The physical location of the transducer has been determined.
• The mounting ring has been installed.
• The steel conduit is mounted with all installation work finalized.
Note
Whenever relevant, all drawings as well as the physical installation of each device must
be approved by the vessel's national registry and corresponding maritime authority
and/or classification society.
The following special tools are required for this installation:
• Torque wrench for the mounting bolts
• Loctite 270 (permanent high-strength threadlocker)
• Lifting device
30
436200/A
Advertisement
Table of Contents
