Table of Contents
Advertisement
Simrad ES38-18/200-18CR Installation Manual
http://www.jotun.com/ww/en/b2b/technical-info/tds/index.aspx
International Marine Coatings
•
: International Marine Coatings
Manufacturer
•
Stoneygate Lane, Felling, Gateshead, Tyne & Wear, NE10 0JY United
Address:
Kingdom
•
Manufacturer's website
Products:
• Intersleek 1100SR
–
: Intersleek 737
Primer
Apply 50 µm dry film thickness.
–
: Intersleek 1100SR
Paint
Apply 150 µm dry film thickness.
• Intersmooth 7465Si SPC
–
: Intergard 269
Primer
Apply 40 µm dry film thickness.
–
: Intersmooth 7465Si SPC
Paint
Apply 100 µm dry film thickness.
The list can also be found on http://www.simrad.com.
Inspecting and cleaning the transducer face
Marine growth (biological fouling) on the transducer face reduces the ES38-18/200-18CR
performance. For this reason, it is important to keep the transducer face clean. Every
time your vessel is in dry dock, you must remove the marine growth. At the same time,
you must inspect the transducer closely for physical damage.
Prerequisites
The following tools and consumables are required.
• Personal protection
• Fresh water
• A mild synthetic detergent and a plastic brush
• A piece of wood or plastic without sharp corners
• Citric acid (<50%) (only if required)
16
:
www.international-marine.com
436200/A
Advertisement
Table of Contents
