Wall Mount The Device - Cisco ASR-920-20SZ-M Hardware Installation Manual

Install the Router
Figure 17: Wall Mount Bracket
Step 2
Secure the bracket to the device with the recommended maximum torque of 10 inch-pounds (1.1 newton
meters).

Wall Mount the Device

Note Install cable guides before mounting the device on the wall.
Procedure
Step 1
Position the cable guide against the front of the device, and align the four screw holes as shown in the figure.
Step 2 Use a tape measure and level to verify that the device is installed straight and on level.
Step 3
Secure the cable guides with four M6x12mm screws that are supplied with the cable kit. The recommended
maximum torque is 26 inch-pounds (3 newton meters).
Cisco ASR-920-20SZ-M Aggregation Services Router Hardware Installation Guide
Wall Mount the Device
35