Philio PHI PST02-1B Quick Start Manual page 3

Choosing a Suitable Location
The recommended mounting height is 160cm
Don"t let the device facing the window or the sunlight.
Don"t let the device facing the source of heat. For instance the heater or the air-condition.
Installation
In the first time, add the device into the Z-WaveTM network. First, make sure the primary controller is in the inclusion mode. And then power on the
device, just take out the insulation Mylar in the back side of the device. The device will auto start the NWI (Network Wide Inclusion) mode. And it
should be included in 5 seconds. You will see the LED light ON one second.
Let the controller associate with the device into the first group, any light switch that intend to be turned on when the device trig please associate with
the device into the second group.
In the accessory pack. There are two type of double coated tape, one is thicker (hereinafter referred to as A tape) and another is thinner (hereinafter
referred to as B tape), you can use A tape for the test at the beginning. The right way for A tape installation is stick it to the position below tamper
key. The thicker tape won"t let the tamper key pressed, so the sensor will enter the test mode, You may test if installed position is good or not by this
way.
After finish the test and decide to fix, then you can remove tape A, and mounting the sensor by using tape B. The tamper key will pressed and let the
sensor enter normal mode.
Inclusion/Exclusion
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate
with the devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave
network. This controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right
on the device.
Inclusion
1. Have Z-Wave Controller entered inclusion mode.
2. Pressing tamper key three times within 1.5 seconds to enter the inclusion mode.
3. After add successful, the device will wake to receive the setting command from Z-Wave Controller about 20 seconds.
Exclusion
1. Have Z-Wave Controller entered exclusion mode.
2. Pressing tamper key three times within 1.5 seconds to enter the exclusion mode.