Using The Show Interfaces Command - Cisco PA-E3 Series Installation And Configuration Manual

Serial port adapter
Hide thumbs Also See for PA-E3 Series:
Table of Contents

Advertisement

Chapter 4
Configuring the PA-E3
VIP in Cisco 7000 Series Routers and Cisco 7500 Series Routers—Example Output of the show diag Command
Following is an example of the show diag command that shows a PA-E3 in port adapter slot 1 on a VIP2
in interface processor slot 1:
Router# show diag 1
Slot 1:

Using the show interfaces Command

Display status information (including the physical slot and interface address) for the interfaces you
specify using the show interfaces command.
For complete descriptions of interface subcommands and the configuration options available for
interfaces, refer to the publications listed in the
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
The following sections provide output of the show interfaces command for some of the supported
platforms:
OL-3502-04
E3 PA port adapter, 2 ports
Port adapter is analyzed
Port adapter insertion time 2w0d ago
EEPROM contents at hardware discovery:
Hardware revision 1.0
Serial number
Test history
EEPROM format version 1
EEPROM contents (hex):
0x20:01 52 01 00 00 D6 8F 79 49 09 14 03 00 00 00 00
0x30:58 00 00 00 99 05 06 00 FF FF FF FF FF FF FF FF
Catalyst RSM/VIP2 in Catalyst 5000 Family Switches—Example Output of the show interfaces
Command, page 4-24
Catalyst 6000 Family FlexWAN Module—Example Output of the show interfaces Command, page
4-24
Cisco 7100 Series Routers—Example Output of the show interfaces Command, page 4-25
Cisco 7200 Series Routers, Cisco 7200 VXR Routers, and Cisco uBR7200 Series
Routers—Example Output of the show interfaces Command, page 4-26
Cisco 7201 Router—Example Output of the show interfaces Command, page 4-27
Cisco 7401ASR Router—Example Output of the show interfaces Command, page 4-27
VIP in Cisco 7000 Series Routers or Cisco 7500 Series Routers—Example Output of the show
interfaces Command, page 4-28
Board revision B0
14061433
Part number
0x0
RMA number
"Related Documentation" section on page
PA-E3 Serial Port Adapter Installation and Configuration
Checking the Configuration
73-2324-03
00-00-00
viii.
4-23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pa-2e3

Table of Contents