Nice Neomat A Series Instructions And Warnings For The Fitter page 5

Table "A3" MANUAL Programming the "0" and "1" positions (fig. 9)
1. Press and hold down key
shutter has reached the required opening position.
2. Press and hold down key
3. Release and then press again key
4. Press and hold down key
position has been memorised.
5. Press and hold down key
shutter has reached the required closing position.
6. Press and hold down key
7. Release and then press again key
8. Press key
been memorised.
N.B.: Key will now control upward movement while key
The upward and downwards movements will stop at the programmed positions.
Table "A4" SEMIAUTOMATIC Programming the "0" and "1" positions (fig. 10)
1. Press and hold down key
opened up completely and the motor stops automatically on the rubber stops.
2. Press and hold down key
3. Release key
4. Press and hold down key
5. Release and then press again key
6. Press and hold down key
position has been memorised.
N.B.: Key will now control the upward movement while key
During ascent, the rolling shutter will stop in correspondence with the rubber stops, whilst during descent in correspondence with the
programmed position.
Table "A5" AUTOMATIC Programming the "0" and "1" positions (fig 11)
1. Check that the rolling-shutter is at the mid travel stage, using the
remote control if necessary to move the rolling-shutter.
2. Press the
until you hear a beeping noise (this will happen after about 5 seconds). Then release the key.
3. Press the
release the key.
4. Press the
beeps.
5. The rolling-shutter should move upwards, if it moves downwards, press the
make the rolling shutter move upwards.
6. The procedure will continue automatically at this stage:
first the system will find position "0" in correspondence with the opening rubber stops;
following this position "1" in correspondence with the closing anti-burglar latches.
7. The procedure is complete when the rolling-shutter is completely closed and 3 beeps
have sounded.
N.B.: Key will now control the upward movement, while key
The upward and downward manoeuvres will stop just before the limits required.
or on a memorised remote control until the rolling
on the transmitter until you hear a beep (approx. 5 seconds)
for 5 more seconds until you hear 4 short beeps
until 3 beeps and a brief movement signal that the opening
or on a memorised remote control until the rolling
on the transmitter until you hear a beep (approx. 5 seconds)
for 5 more seconds until you hear 4 short beeps
until 3 beeps and a brief movement signal that the closing "1" position has
the downward movement.
or on a memorised remote control until the rolling shutter has
to lower the shutter
when the shutter has reached the desired position ("1")
on the transmitter until you hear a beep (approx. 5 seconds)
for 5 more seconds until you hear 4 short beeps
until 3 beeps and a brief movement signal that the closing "1"
key of a transmitter which has already been memorised, and keep it held down
key down for a further 5 seconds until you hear 4 quick beeps, and then
key once again and keep it held down until you hear the first of the two slow
the downward movement.
key or
the downward movement.
Example
Example
Example
on a memorised
key or to
GB
5s
5s
5s
5s
5s
5s
5s
5s
5s
5